Forum Replies Created

Page 68 of 2304
  • Archived

    Member
    April 24, 2021 at 9:26 am in reply to: Tips for Changing Coolant Line from Compressor to

    Mine are still original.2005 chassis, 174,000 miles.

  • Archived

    Member
    April 23, 2021 at 12:05 pm in reply to: Tips for Changing Coolant Line from Compressor to
  • Archived

    Member
    April 23, 2021 at 11:35 am in reply to: Tips for Changing Coolant Line from Compressor to

    Use a crowfoot wrench on an extension and rachet.

  • Archived

    Member
    April 22, 2021 at 10:18 pm in reply to: Bus Not Raising to Drive Height

    Great post Jon, you covered a lot. It’s a keeper.

  • Archived

    Member
    April 22, 2021 at 8:29 am in reply to: Prevost slide room locks

    Bill, they’re Prevost authorized. I couldn’t get the link to copy, but just Google

    Luxtor RV service.

  • Archived

    Member
    April 21, 2021 at 9:14 pm in reply to: Bus Not Raising to Drive Height

    Thanks, still trying to learn about this thing, so where exactly do I need to check and drain water from the system?

  • Archived

    Member
    April 20, 2021 at 6:29 pm in reply to: Prevost slide room locks

    Larry you have Prevost slides in yours I would pull into Prevost and get it checked.

    They’ll know what it is without throwing parts at it to fix it.

    Later

    bv

  • Archived

    Member
    April 20, 2021 at 5:12 pm in reply to: Prevost slide room locks

    Marathon mainly uses Prevost slides for all 2 slide coaches. Some 2 slide Valids were produced so you need to check your bus or build sheet.

    Pin slides were done as of 2005 chassis and last generation slides started in the 06 chassis year.

    I think A1’s pendant is for his leveling system Larry, you only have the level low which I prefer.

    Larry, call Coburg.

    Later

    bv

  • Archived

    Member
    April 20, 2021 at 4:12 pm in reply to: Prevost slide room locks

    Jon, I’m not familiar with the Pendant. I suspect my bus isn’t equipped.

  • Archived

    Member
    April 20, 2021 at 1:14 pm in reply to: Prevost slide room locks

    Larry,

    I’ve been through this before……at all costs….make sure the slide is in the correct position before firing the pins. Mis-firing when not in position may result in significant damage.

  • Archived

    Member
    April 20, 2021 at 7:55 am in reply to: Been Awhile

    Definitely OK to post the photos in the flea market Cliff. Hope you are doing well.

  • Archived

    Member
    April 19, 2021 at 7:03 pm in reply to: Amber & Red check engine lights?? And over ride

    I bought 2 Kent Moore J-38500 Pro Link Scan tools and a Kent Moore J-37164-DDEC Sensor Tester and at Auction a while back. Neither has the cartridge’s. Same as the Pro Link Scan tools. The Sensor Tester is intact with all wiring.If somebody need to borrow one, holler.

  • Archived

    Member
    April 19, 2021 at 2:33 pm in reply to: Bus Not Raising to Drive Height

    Check the center solenoid valve coil in the 5 valve manifold that is in the steer compartment.

  • Archived

    Member
    April 19, 2021 at 2:06 pm in reply to: Bus Not Raising to Drive Height

    HI. mine has done the same thing a couple times. and i have found the electrical plug off the manifold had uncoupled or had a bad connection. may have been due to me in that area working on something. just a thought.

  • Archived

    Member
    April 19, 2021 at 12:54 pm in reply to: How far do I go with this? etc. 1989 XL CC 8v92TA

    Liam, great find! PM sent. John

Page 68 of 2304