[Archived]

yes, the Crestron can be rebooted. Before the upgrade this was done in my coach by tripping the GFI next too the sink in the bedroom. If that doesn’t work i would certainly call Troy.

[Peter]

I’d like to make some simple (at least I think they should be simple) changes to our Crestron system (I think we have a Crestron system).

1. When the door opens, the Sunmulon switches should lite up without having to push a button on the pad for the switch pad lights. When the door closes, the lights in the switches could go off.

2. When a light/function is “off” the Sunmulon switch should be “red”. When the light/function is “on”, the switch should be “green”. Right now our lights don’t change color when the switch is pushed; but the color of the Sunmulon switches in George and Corey’s Vantare do! I suspect that we might need different Sunmulon switches to change colors (I presume our switches have one light in the switch, George & Corey’s Vantage has two lights (one green, one red) in the switches).

3. Probably the same change on the touch screens. Seems like when something is “on” the icon is “red”, when its “off” the icon is “green”. I think logically that is reversed over what it should be. If my logic if flawed, I’m open to being educated. You guys and gals with fancy aircraft, what do the colors on the switches and pushbuttons in our planes mean?

4. I sleep on the right side of the bed. The Creston touch screen in the bedroom is on the left side. I would like to add a small array of Sunmulon pushbutton switches on the right side inside the little drop down door that has the car stereo that rarely gets used.

Seeing what I’d like to do, is it easy or extremely difficult (expensive) to do what I’d like to do?

Has anyone ever used the Sunmolun switches in other applications? Like using them as light swtiches in a house or office? I presume they operate at low voltage (12 or 24 volt) and operate a relay that controls the 120volt or 240volt circuit.

[Peter]

They make them in 5, 12 and 24 volt configurations.

I don’t know how hard it would be to add a set of swithces but I am sure it would not be cheap.

The circuit boards the switches go on would have to be made and then the cabling would have to go to the main control unit where all the other switches and the circuit boards are located.

We all have switches located in multipul locations the control the same lights or other devices.