I considered using a ducted unit in my bus since I freed up an entire bay by deleting the OTR HVAC. I couldn’t find any that were 120v, only 240v. I thought that might limit me in some power situations, although I haven’t really settled on my electrical design. The 240v outdoor units were also too tall for my bays. I’d love to avoid…

Read more

While we’re in the engine compartment, I also completely rebuilt the rear electrical panel. Not sure if I posted about that before. I’m also not sure if I did a good job, because I haven’t tried starting the engine since last summer. Sure looks nice though! I’ll have to find better before and after photos for this job, but I…

Read more

I also replaced the plywood covering the top of the engine compartment. It had a lot of rot, I suppose due to years of the Cruisair evaporator freezing and then melting everywhere. No other signs of water penetration back there. I replaced the fiberglass insulation and what I guess is meant as a vapor barrier, using foam board and a nice,…

Read more

I don’t have any drawings to post yet, but am at a point where I need to decide. It really is a game of inches. My main goals at this point:

1. change from side aisle to center aisle

2. make moving around the bed less of a squeeze

3. make the bathroom less cramped

4. incorporate a larger refrigerator

Everything else is really just…

Read more

Bill – Home Builders seems like the wrong spot for a complete renovation?