-
Tail Light Adapter
My ‘92 has yellow turns, red markers, and red brake lights – all independent.
My Jeep has the 2-wire, everything in one taillights.
Can someone help me find the right wiring adapter please?
My shop installed this – and thank god I don’t drive at night – because when the bus markers are on, they override the turn signals.
-
8 Replies
-
Hey Liam,
I have that same problem when the running lights are on the signal lights are not fully blinking it seems like they not getting full power. I have a tail light converter but I am open for suggestions. The running lights, brake lights and brakes work fine on the trailer it’s just the signal lights that are weak. ???
-
I switched to Jeep LED tail lights to get more brightness. Hopefully someone else in the club has solved this.
-
Look at CoolTech Wiring Harness for Jeep
-
I’ve always used the Hopkins light kit, plug and play, 4 wire to the front then I use 6 round to the Jeep. No wires to cut or splice.
-
The unit in the picture is correct, maybe it is wired incorrectly?
-
Mike, on the Roadmaster unit – where do the Prevost marker lights connect? Thanks
-
OK, found this diagram on the web. Helpful. So the marker light feed should go directly from the bus to the lights and not through the gizmo.
-
The unit in the picture is called a combiner. It does nothing with or for the marker lights. The marker lights do not go thru that device. Turn and brake only.
Log in to reply.