Prevost Community Forums

Find answers, ask questions, and connect with our
Prevost Community around the world.

  • Posted by Dean on January 14, 2016 at 9:19 am

    My two operating windows in the salon will squeak while going down the road. If you open the latch and then re-latch the window it will stop squeaking for awhile and then start up again. I have to assume it’s the glass rubbing against the seal. What can I put on the seal to stop the squeak?

    Ronald replied 10 years, 7 months ago 11 Members · 14 Replies
  • 14 Replies
  • AL

    Member
    January 14, 2016 at 10:03 am

    Silicon spray?

  • Tim

    Member
    January 14, 2016 at 10:17 am

    We had the Driver Side window squeak. We bought some weather stripping and applied it to the bottom of the window. Solved the problem. It does make closing the latch slightly harder to close but the squeak is gone!

    We are just 20 coaches newer than yours!

  • Walter

    Member
    January 14, 2016 at 10:18 am

    There are small steel balls that are in the latch. I would take wild guess they are missing. You must be very careful closing and opening as those balls pop out if latch moves past position.

    Second place screens . Use the small felt dots to cushion the screen against frame.

    Third place rubber seal around frame allows frame to hit piston linkage.

    AL

  • Tim

    Member
    January 14, 2016 at 10:54 pm

    How to fix the missing balls, Al?

  • Archived

    Member
    January 15, 2016 at 12:52 am

    Implants. Geo.

  • Archived

    Member
    January 15, 2016 at 3:42 pm

    Heidi is convinced it’s the latch. Putting pressure on the latch will stop the squeaking. I know it’s not the screens because I took them out and put them in the basement for one trip and they still sneaked. Thanks for the suggestions.

  • Larry & Diane

    Member
    January 15, 2016 at 11:27 pm

    Same here, Dean. It drives me crazy and Natalie can’t hear it. If you come up with a solution please post. I’d gladly change out the latch if that’s possible.

    BTW, I find it’s worse when cold and when the road is rough.

  • Joanne

    Member
    January 16, 2016 at 12:03 pm

    Dear sluggos,

    Listen to Heidi and Natalie as they are correct.

    It’s the latch steel ball, it’s missing. Disappears when someone forces the latch handle to far causing the steel ball to come out. I found mine laying in a corner of the window frame.

    Use grease to hold ball in place after taking latch apart. Some old time hardware stores have steel balls. To determine size measure slot width.

  • Bernie

    Member
    January 20, 2016 at 8:39 am

    Al, do you have a picture of what to look for?

  • Walter

    Member
    January 20, 2016 at 9:24 am

    Sorry, sold the bus with top hinge window….are you going to Lakeland rally ?

  • Archived

    Member
    January 20, 2016 at 9:37 am

    No sir

  • Ronald

    Member
    January 20, 2016 at 8:53 pm

    I couldn’t find any ball bearing in our latch nor could I figure out where one would go. I did libricste the Windows seals with silicone lubricant and driving back to Ft. Myers from Tampa, No Squeaks!!! Quiet smooth ride. Awesome!

  • Archived

    Member
    January 21, 2016 at 10:40 am

    Dean, are you attending Lakeland ?

  • Brian

    Member
    January 22, 2016 at 6:24 pm

    Lakeland? No we won’t be there.

Log in to reply.