-
Splendide or Not
When I purchased our bus four years ago, the previous owner told me the Splendide washer/dryer worked the last time they used it but that was three years earlier. As I was checking out the washer I found that the program selector swich was not working. I took the switch apart and cleaned the contacts. Over the years of non-use, corrision built up and would not allow the contactc to meet. Since then, it has run very well and we have been very pleased with one exception. When it tries to start the spin cycle we need to be ready to move. It starts jumping and bouncing like crazy. We have to stop the machine and try to distribute the cloths around the drum a little and then restart the machine. If we can get it to start smoothly, all is well and it will finish the process without issue.
The last time we were out, something strange happened. When it reached the spin cycle, we were not aware if it, but the water did not drain. In fact when it got to the rinse cycle it added even more water. That is when I heard my wife calling saying the washer was leaking water all over the floor. When I got back inside I found the water level near the top of the door. We spun the dial around and fortunately, when it hit the spin cycle again the pump ran and reduced the water level to just below what you would expect for washing, but that was it. Spun the dial again, more water – no pump. Again, more water – no pump. Before I knew it the water is half way up the door again and still leaking out of the door again.
I do have to say that this is a Model 804 and dates to the original conversion of 1991.
Since we returned home, I have pulled it out and tested the pump motor. Works fine. Now I am now looking at the presure switch to see if that is the gum in the works. Then on to the selector switch and controller board. I think I can chase it down with a little time and effort.
But as I am chasing the issue, I can not help but wonder if I should even be chasing issues on a 25 year old machine. I would think that the newer machines have many more features. In reading a number of posts, I gather that the 2100 has increased spin speed which reduces dryer time but also has a slow spin setting for things like blankets. And the new ones are more energy efficient – always a good thing.
So my question is, am I penny wise and pound fullish for trying to fix this antique, or should I just bite the bullet and get a new unit. And if I should get a new unit should I consider something other than a Splendide like an LG or something else. What ever I get I would want a vented model and I need to get a combo model instead of stacking. (I do not want to loose my only full length closet)
I know that many of you have been through this process, so any advise would be appriciated.
Log in to reply.