Prevost Community Forums

Find answers, ask questions, and connect with our
Prevost Community around the world.

  • Archived

    Member
    June 7, 2015 at 2:35 pm

    If you are asking how to

    Xtreme Paint and Graphics gets SS panels in mill finish. A 3.5 hp motor on a flex cable and buffing wheel using black rouge to start with and hours of running that wheel back and forth on the panel gets a mirror finish. The panel is new and has no scratches. Scratches could be sanded out first.

    Process turns worker black and tired. Hope this helps.

  • Michael

    Member
    June 7, 2015 at 5:14 pm

    Polishing stainless, either to touch up a repair, or to do an entire coach is not for someone that does not have training or skills.

    While the process can be easily described, step by step, it will all boil down to the polisher using extreme care to avoid hurrying the process, and especially to limit or avoid heating the panels. Once a panel is overheated during the process it warps and looks very bad. Equally critical is uniformity. Every square inch of every panel needs the same amount of sanding and buffing so the quality of the finish is uniform.

    Sanding???? Yes. use progressively finer grits, and before buffing end up with at least 1500, and if possible even finer grit. Then begin buffing, usually ending up with white rouge or a compound less agressive.

    For those unskilled a good place to practice is on the raw aluminum wheels, and then if comfortable try buffing thicker surfaces like the stainless on the front bumper. Thicker surfaces are much more forgivving, and the smaller the surface the less uneven polishing is evident.

Log in to reply.