-
How to wire guest charger to vanner
I Am new to the prevost world I have a 2000 country coach h3-45. It has a vanner volt master 100 amp with a vanner em70c monitor and no charger hooked up I purchased a guest charger with two sets of charge leads 10 amp each anybody know the best way to wire it up it has the battery leads from the volt master to the battery’s 12 and 24 volt thanks Jim
-
6 Replies
-
1. It would help if you identified the model number of the guest charger.
2. Are you sure you are going to wire to the Vanner?
I have a guest installed and it has 110-120 VAC input which was slated for the engine block heater. The DC leads are connected right to the batteries.
-
its a 2620a not sure if it should be wired to the vanner or just be wired to two of the 12 volt batteries direct
-
The Guest 24 volt charger usually allows a 24 volt bank of batteries to be charged at 24 volts or as two separate 12 volt batteries or banks of 12 volt batteries.
I have seen the charger connected to the batteries, not the equalizer, but that does not necessarily mean connecting to the equalized is not allowed. I would follow the installation instructions that come with the charger.
-
I’ve installed several Quests and wired them using (2) 12’s or to 24 volt directly to the batteries. Wiring to the Vanner would sure be easier, but you may want to ask Vanner that question. Seems logical, the cables from the batteries are home runs to the Vanner.
-
-
Log in to reply.