Prevost Community Forums

Find answers, ask questions, and connect with our
Prevost Community around the world.

  • CAN I REMOVE COMPRESSOR AND ITS HARDWARE

    Posted by james on December 25, 2015 at 10:08 pm

    OKAY this post is for your help. can i remove a ac copressor and its lines condensor etc .on a 1988

    prevost xl .and use roof ac units . make room for gen etc or will this mess up heating system by removing lh side copper pipes .or are thease independent of each other.and is this stuff saleable.

    Archived replied 10 years, 10 months ago 3 Members · 2 Replies
  • 2 Replies
  • Tommy

    Member
    December 26, 2015 at 12:38 pm

    You will have a tough time removing all the copper pipes and yes some are used for heating. I had a GMC PD4107 the AC system was shot so I removed the Compressor and didn’t touch the copper lines (actually used some as wire AC. Used the Compressor compartment to relocate the batteries.

  • Archived

    Member
    December 26, 2015 at 4:41 pm

    on curb side from compressor go foward over wheel well then back down into condensor compartment then cross over bus to drive side to evap compartment. Hot water travel down drivers side foward above wheel then back down to evap/heat exchanger compartment then from there a pair of smaller lines travel to center of coach foward to defroster/front drivers heat exchanger in center of dash.

Log in to reply.