Prevost Community Forums

Find answers, ask questions, and connect with our
Prevost Community around the world.

  • 12 volt source

    Posted by Craig on December 11, 2017 at 6:44 am

    Any of you folks using a Remco lube pump for your Toad? I need need to get a 12 volt source from the front to the back . For the Remco control panel. I have been told there are some spare wires possibly.

    Thank You

    Craig

    Archived replied 8 years, 10 months ago 4 Members · 4 Replies
  • 4 Replies
  • Archived

    Member
    December 11, 2017 at 7:01 am

    The rear electric box has 12 volts in it. You can get a little creative also and either find a circuit that is “hot” only when the engine is running, or tie into one that is always hot as long as you remember to shut it off every time you shut off the coach.

    I grabbed 24 volts from an alternator circuit (going by memory here) and that could be used to close contacts on a relay to open or close the 12 volt power supply to the Remco.

  • Andre

    Member
    December 11, 2017 at 7:30 am

    There are spare wires run from front to rear, but access is likely different based on year and model.

  • Archived

    Member
    December 11, 2017 at 7:35 am

    On our 1999 Royale there were spare wires in the door just under the drivers side window. They were tucked into the wiring bundle at the bottom of that compartment. They ran all the way to the rear run box above the engine. It takes a little digging to find them. Each wire has a number in it that will ID it both front and rear. If I remember correctly all the spare wires were grey in color.

  • DON

    Member
    December 11, 2017 at 7:56 am

    Thank You everyone for your replies . The information you have provided will give me a good starting point.

Log in to reply.