Prevost Community Forums

Find answers, ask questions, and connect with our
Prevost Community around the world.

  • Chassis

    Shock installation

    Posted by Art on May 6, 2020 at 8:42 pm

    Got 4 out of the 6 shocks off, new shocks will be here tomorrow, cleaned off shafts where shock grommets ride, lots of rubber on them. should I put anything on shafts for new shock grommets??

    Mark replied 6 years, 4 months ago 5 Members · 4 Replies
  • 4 Replies

  • Chuck & Katrina

    Member
    May 7, 2020 at 5:46 am

    Does the service manual call for anything?

    2000 Featherlite H3-45

    2024 Jeep Grand Cherokee

    Leesburg, FL

  • Mark

    Member
    May 7, 2020 at 9:18 am

    The last set I did I just put a light coat of grease on the shaft.

  • Rudy

    Member
    May 7, 2020 at 9:20 am

    doesn’ say, the old shocks were on for 22 years so that’s why there was some rubber on the shafts, so I cleaned shafts and i’m just going to put them on dry.

  • Archived

    Member
    May 7, 2020 at 9:32 am

    I’ve always replaced my own, more sets than I can count, about every 5 or 6 years, and always replaced them dry. I suppose I should have looked in the book, but a part with 2 nuts to remove and replace didn’t seem like there would be much of a how-to list.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .