Prevost Community Forums

Find answers, ask questions, and connect with our
Prevost Community around the world.

  • Black Water Tank to pipe sealant?

    Posted by Archived on February 14, 2016 at 7:31 am

    Well, I found a long time slow fresh water tank leak and restoration has forced me to strip the water bay of all the tanks.

    What is the correct sealant for the Black and Gray water tank (ABS plastic) to ABS piping? It appears to be a chalk or plumbers putty but what type? The old stuff is still slighty soft, yet very difficult to remove. The tank nozzle is flush with the tank bottom and extends a couple of inches, it appears to be the hard ABS plastic as well but it does have a hose clamp around it. I think a ABS pipe nipple fits inside the tank nozzle but I have not taken the joint apart yet. This does not appear to be a screw joint.

    4 Questions:

    Correct Sealant for the tank discharge lines? (I sure don’t want a leak there).

    Correct sealant for the rubber tank grommets used for attaching the inlet drain lines?

    Best way to get the tank to pipe joint apart whithout damaging the nozzle?

    Any routine maintentance items I should address in the rear bay while I have all the tanks out and access to the bulkhead just in front of the drive axel and fuel tank tank access panel?

    AL replied 10 years, 9 months ago 2 Members · 2 Replies
  • 2 Replies
  • Archived

    Member
    February 14, 2016 at 8:23 am

    Joe, a leaking tank can destroy the wood floor in a bay. I hope it has not yet done so. My point is that is a question that should be directed to a manufacturer of sealants. They will want to know the specific materials and the application before they can make a recommendation. With all the work you have ahead of you it is likely the guy at the hardware store may not offer the best answer.

  • AL

    Member
    February 14, 2016 at 2:38 pm


    the bay has been wet once before in my ownership ( leaking surflo pump head) but this time it appears the leak was at the drain line tank nozzle. I pulled the water tank thinking it was the tank ( it was not) but the bay has been wet a number of times and the ply is toast. No make that a spong. The ramp or wedge the black and gray tanks sit on was made of ply turned on edge. The ramp was falling apart. Based on the amount of stuff under the tank and ramp I think it has been wet many times over the 20 year life.

    Never saw any water in the bay. Only the floor of the barn. Ben leaking a few weeks I expect.

    Thus us my decision to strip it and start clean. Go back with all new connections.

    Got out to get a move on with this as I need a functional bay for maintenance seminar 3.

    Thanks in advance for any advice.

Log in to reply.