• Electrical

  Fuel, Boost and Temp Gage Not Working!

  Posted by Chad on August 27, 2015 at 12:46 pm

  Had chassis batteries replaced last week, along with

  a starter relay. Now my fuel, boost and temp gages on

  dash aren’t working, all relays and breakers in outside

  drivers panel seem to be ok…….Anybody?

  MetalManChad

  2006 H3-45DS Marathon
  

  

  Archived replied 11 years, 2 months ago 2 Members · 2 Replies
• 2 Replies

• 

  Archived

  Member

  August 27, 2015 at 7:21 pm

  Chad,

  The gauges you mention are two separate clusters. Are all the other needle gauges and Telltale working properly? I’m assuming your using the bus and it starts and runs OK. If not, is the master switch in the rear battery bay in the on position? Is the manual run switch in the engine bay in the normal position? You have breakers and fuses in both rear small bay doors, where the chassis batteries are located and on the drivers side forward of the radiator.

• 

  Archived

  Member

  August 28, 2015 at 3:31 pm

  Chad
  
  I recently had the same issue. I could not find the cause of the problem, so I then tripped all the breakers in each of the three exterior bays, left them off for about 2 hours, then reset them all. Started the bus up and everything was back to normal.
  
  Alex

Log In to Reply