-
Code Reader
Every now and then we get codes. Our coaches have codes relating to the engine, transmission and ABS brakes.
There is a distinct benefit to reading the codes and obtaining detail to help you understand what is going on and if you have a situation that requires immediate attention or service when you get an opportunity. On my current coach and the previous one I had a code reader with the appropriate software for my particular generation of DDEC and my ABS.
To give a few examples of how an owner can benefit I got an array of codes when the charge air cooler leaks were getting worse. I not only could read the fault code, I could clear it, but I could also view the engine data to satisfy myself all the data readings were well within the safe operating range and continued driving wasn’t going to hurt anything.
I also had an intermittent ABS light and reading the code told me it was a rear passenger side sensor that wasn’t getting a reading due to a larger than acceptable gap. Tapping the ABS sensor in a little made that fault code go away.
My point is whether you use a device such as Ray Davis has created for your ipad or you go on ebay like I did to find a used Nexiq reader with software you are going to be much more comfortable knowing what is going on with your coach. My first reader was $225 but I had to get DDEC III software, my current reader was $1000 but I got DDEC V, ABS, and generic Detroit Diesel software with it. You can plug it in beneath the dash on the left side or at the rear under the bottom of the rear electric box. It is easy to use, as is the device Ray has created. I think newer coaches have all the diagnostic ability available through the message center, but I do not know about the ability to clear or reset codes or read the plethora (how about that word?) of data points that are available.
Sorry, there were no replies found.
Log in to reply.